Post here when you run into specific project-related trouble and need help!
Everyone runs into problems in woodworking, regardless of the experience level. Woodworkers of all experience levels are constantly finding a better,...
Ok,found a little gold nugget in the shop today from my father-in-law.I came across a single round outlet that i thought was a NEMA 5-20R (110V 20amp...
I am in the process of building a new workshop and have used tongue and groove sheets of 3/4" AdvanTech (an engineered, moisture resistant and strong...
I am building a ladder style bookcase (i.e. 2 legs leaning against the wall with shelves as the "rungs.") I need to attach 1/4" plywood to 1" x 3"...
When using pocket screws do you also use wood glue for extra strength or just the screws? On the project I am assembling, I have no intention of...
I recently bought some lumber that is flat, but has a lot of wavy edges. I have read about the tip of fixing a plywood straight edge to act as a...
I had no idea finding maple would be so hard here in San Antonio. I wanted to get a 2 ft board that I could cut down into 3/4 strips and make...
I made a bowl on my lathe about 4"T or Deep (depending on your view) and 5"W or round. it is spalted Oak. as usual there were the punky spots that...
I have an outdoor patio with a combination potting table/serving/entertaining cabinet. It is about 8' long with two sets of doors behind which are...
Use this control to limit the display of threads to those newer than the specified time frame.
Allows you to choose the data by which the thread list will be sorted.
Order threads in...
Note: when sorting by date, 'descending order' will show the newest results first.
Forum Rules
