Forum: The Good Guys

Vote for the manufacturer that has given you the best customer service.

I have had my PM2000 for over three years now and managed to bust the sliding key that locks the arbor for changing the blade. See the photo below...

Incra have been amazing and supplied the fence for my shaper table as I didn't like the JET original, couldn't help me enough, as a result I have ...

I recently purchased some Accuride drawer slides on-line which did not come with screws. I know that the right screw must be used to mount these...

Leigh Jigs has always been one of my "good guys" because they take care of their customers. the following is just the most recent example. The...

Got to give Advantage Trim and Lumber a mention. I took a delivery of just under 1800 board feet this week from Advantage and they donated a load...

Hey all,do to small shopitis i needed a smaller HIGH QUALITY router table.It has loads of big table features.One of the biggest features for me was...

I have had the opportunity to purchase multiple items from Rockler. Each time I have done so, they have had the items I wanted in stock and...

If you are thinking about purchasing plans from NWW but are not sure about the value or quality read on. These plans are very detailed and very well...

I was recently trying to find a simple removable splitter for my DELTA 36-979 10" Left-Tilt Contractor's Saw. The saw originally came with a one...

This isn't a retailer but a site devoted to listing and comparing tools as well as highlighting good deals (Tom, please move it to a more appropriate...

I would like to give a shout out to Festool USA for progressive thinking in providing a valuable service to their customers. They are preparing to...